Welding Instructions

  XX WELDAHUBS ® can be used with the following  
WELDASPROCKETS ® sizes: 
Minimum sizes: 4024X, 5020X, 6017X, 8014X, 10013X
 
 WELDAHUBS ® STOCK NUMBERS ARE FOUND ON PAGES 31, 32 & 33
We recommend using Low Hydrogen Electrodes for welding WELDASPROCKET ® parts.
          
The smaller 
WELDASPROCKETS ®
should be welded as 
shown so the weld 
will not interfere with 
the chain. 
WELDING G&G IDLER HUBS
The assembly of G&G Idler Hubs into a WELDASPROCKET ® or WELDAPULLEY ® is a relatively simple operation. As with WELDAHUBS ®, the two parts are clamped 
together and stitch welded using low hydrogen electrodes, Three (3) or four (4) 
stitches 5/8’’ to 3/4’’ long will be sufficient. Care must be taken to make sure the 
welding ground circuit does not pass through the bearing itself. Excessive weldingheat may cause distortion or damage to the bearing.

 The larger WELDASPROCKETS ® heat may cause distortion or damage to the bearing should be welded as shown.